Our first 2 models are the The Python Separator I (Wt. 950#) and the The Python Separator II (Wt. 1,000#). These 2 models have a good capacity load and can each separate products at 10 gallons per minute. Models 1 and 2 come with a 2 HP, 3 Phase motor and is Standard with 220/440 volt. The regulator on the air cylinder would be set at 80 psi. The The Python Separator II has a drive shaft/auger assembly and the welds are continuous….making it an easier washdown model. The drive shaft requires 2 pillow block bearings compared to The Python Separator I’s single pillow block bearing. Our 3rd model is the The Super Python Separator (Wt. 1,300#). This model is similar to the The Python Separator II model in regards to the pull apart auger system. It has an 8″ auger and tube and a larger hopper. Capable of handling your heavy loads!

1. All heavy stainless steel (304) construction. The original machine has been in operation since 1984 without a major break down. It has separated approximately 4,000 gallons weekly. This machine, its construction and method of operation is patented.
2. Low energy requirements, 2 HP 3 Phase motor. Machine is Standard with 220/440 volt.
3. All grab and pinch points effectively guarded.
4. Splash curtains control splattering milk and are easily removed for cleaning and scrubbing as needed.
5. Machine comes with 20’ cord ready for power hookup.
6. Machine stops when lid is opened.
7. Intake opening is designed so a case cannot be inserted in the machine.
8. The only moving part, the compression auger, is slow moving and nearly impossible to be reached through the entry opening.
9. Machine is approximately 41 inches wide, 94 inches long and 53 inches tall.
10. Heavy casters are utilized to roll machine to storage and cleanup.
11. Receiver tank is constructed of polished stainless steel with a 2 inch dairy fitting on drain end.
12. Receiver tank contains a removable strainer basket constructed of expanded stainless steel mesh. Strainer basket catches small pieces of plastic and paper that occasionally pass through with product.
13. The discharge and compaction chamber is equipped with a pneumatic cylinder to maintain a constant pressure on containers being discharged. This cylinder is furnished with a regulator and gauge to obtain the desired compaction.
14. Electrical controls are contained in a 4X rated enclosure. Controls include START/STOP buttons with pilot light, two large safety shut off buttons, and automatic shut off if hopper is opened.
15. Very few parts require OEM purchase. Most components are off the shelf.
16. The machine warranty is one year from receiving the machine and limited to machine only. All purchase items including motor, drive unit, bearings, gears, chain, electrical controls and equipment will be warranted only to the extent of the manufacturer who produced and sold them. Warranty voided if it is determined that the machine was subjected to severe misuse and abuse. Frozen product is not recommended.​

(Designed for easier cleaning)

1. All above listed points apply also to Python Separator II.
2. The Python II has a drive shaft/auger assembly. The welds are continuous and polished.
3. The drive shaft requires two pillow block bearings.
4. The reinforcement rods located in the barrel are continuous and polished.
5. There are slight differences in the construction of the two models also.

This model is similar to the Python 2 model in regards to the pull apart auger system. It has an 8″ auger and tube and a larger hopper. Capable of handling your heavy loads!